Get in Touch Now

+971-524470640

Phone Number

+971 52 447 0640

Contact us today for the Free Quote

Alkaline RO Dispenser

Drink Alkaline Water in your office Hot/ Cold/ Normal 3 taps 3 options

The pH level of all water varies dependent on the source for that water.
Experts state that natural water from a spring typically has a pH that is acidic.
Those that are advocates of alkaline water believe that drinking water that is alkaline will help neutralize acid in the bloodstream,
leading to increased oxygen levels as well as increased energy and metabolism.
However, clinical research has not been able to validate these benefits.

RO Features

50 GPD/TFC membrane
5 micron sediment filter
Two GAC in-line filters
Post carbon in-line filter
In-line Alkaline Filter ( Purepro Made in USA)

Fully assembled

All hardware included
Automatic tank full control
Booster pump (CWC-929P only)

Specifications:

Production: 50/75/100 GPD
Input in AC 110Volt, 220Volt or 240Volt (50/60Hz).
Operation feed water pressure: 50 psi

Cooler Features:

Microprocessor control
Easy access all the controls and filter cartridges
Independent Hot/Cold power switches
Re-heating up to 100°C
Built-in 6 stage RO system
Tri-Temp; room, cold and hot water supply
Automatic heating shut-off when hot tank is empty
2.5 gallon capacity reservoir

What the system is and what problem it solves

The Alkaline RO Dispenser is an all-in-one drinking water system designed for offices and small commercial spaces that require purified water with hot, cold, and room-temperature options. It integrates a 6-stage reverse osmosis system with an alkaline filter to produce clean, low-TDS water while improving taste and mineral balance.

The unit combines purification, heating, cooling, and dispensing in a single appliance, eliminating the need for separate filtration and water-cooler systems. Its built-in microprocessor controls monitor heating, cooling, tank levels, and safety protections for reliable daily use.

Process Design & Operating Philosophy

Water passes through a sediment filter and two stages of activated carbon before entering the TFC RO membrane. The RO membrane reduces dissolved solids, chemical contaminants, and microorganisms. Post-carbon polishing improves taste, while the in-line alkaline filter increases pH and enhances mineral content.

Purified water is stored in an internal reservoir and supplied through three dispensing options: hot, cold, and room temperature. Automatic shut-off protects the heating tank when empty, and independent switches allow selective control of hot and cold functions.

Design Basis & Engineering Assumptions

Parameter	Design Basis
Water Production Capacity	50 / 75 / 100 GPD
Filtration Stages	6-stage RO + alkaline filter
Input Voltage	110V / 220V / 240V (50/60 Hz)
Operating Pressure	~50 psi
Hot Water Heating	Up to 100°C
System Type	Floor-standing RO dispenser (Tri-Temp)

Actual performance may vary based on inlet pressure and temperature conditions.

Dispenser Features

Microprocessor-controlled operation
Easy access to control panel and filter compartment
Independent hot and cold power switches
Re-heating capability up to 100°C
Built-in RO filtration system
Three water options: hot / cold / room
Auto shut-off protection when hot tank is empty
2.5-gallon internal storage reservoir
The system is delivered fully assembled with all installation hardware included.

Performance Parameters

Parameter	Parameter
RO Production	50–100 GPD
Dispensing Options	Hot, cold, room temperature
Hot Water Temperature	Up to 100°C
Reservoir Capacity	2.5 gallons
Monitoring	Microprocessor with safety protections
System Control	Automatic tank-level and heating control

Actual results vary based on water quality and operating conditions.

Pretreatment & Integration Requirements

Pretreatment requirements include:

Sediment filtration (included)
Chlorine reduction (two carbon filters included)
Adequate inlet pressure—booster pump supports low-pressure sites
Routine replacement of RO and carbon cartridges

Additional protection such as UV disinfection can be added if required.

Models

Model Number	Permeate Flow (GPD)	Note
AL-50-RO	50 GPD	Standard tri-temperature alkaline dispenser
AL-75-RO	75 GPD	Higher-capacity RO configuration
AL-100-RO	100 GPD	Maximum production model

Note: Model numbers and configurations can be customized based on specific feedwater quality and site requirements.

Features

Standard Features:

Built-in 6-stage RO purification
In-line alkaline filter (USA-made)
Three dispensing temperatures
Microprocessor operation
Automatic tank-full control
Independent hot/cold switches
High-temperature heating capability
Internal 2.5-gallon storage reservoir
Complete installation hardware included

Available Options

Booster pump (included in selected models)
UV disinfection module (external option)
Larger external storage tank
Leak detection system
TDS monitoring device

Applications

Office drinking-water stations
Corporate workspaces
Clinics and healthcare rooms
Retail and commercial service areas
Staff kitchens and break rooms
Locations requiring purified hot, cold, and ambient water

System Components

Certified Parts. Proven Performance.

We use certified components sourced from trusted global manufacturers to ensure system durability, operational stability, and regulatory compliance. From membranes and pumps to control panels and filtration media, every part is selected to support long-term performance and ease of maintenance.